Epson VT6L User Manual

Setup & Operation 14. I/O Remote Settings
102 VT Rev.1
(*2)
“Start input” executes Function specified by the following six bits: SelProg 1, 2, 4, 8, 16, and 32.
Function name
SelProg1
SelProg2
SelProg4
SelProg8
SelProg16
SelProg32
Main
0
0
0
0
0
0
Main1
1
0
0
0
0
0
Main2
0
1
0
0
0
0
Main3
1
1
0
0
0
0
.
.
.
Main60
0
0
1
1
1
1
Main61
1
0
1
1
1
1
Main62
0
1
1
1
1
1
Main63
1
1
1
1
1
1
0=OFF, 1=ON
(*3) “NoPause task” and “NoEmgAbort task” do not pause.
For details, refer to EPSON RC+ 7.0 Online Help or Pause in SPEL
+
Language Reference.
(*4) Turns OFF the I/O output and initializes the manipulator parameter.
For details, refer to EPSON RC+ 7.0 Online Help or Reset in SPEL
+
Language Reference.
(*5) VT series is invalid.
(*6) Initializes the manipulator parameter.
For details, refer to EPSON RC+ 7.0 Online Help or Motor in SPEL
+
Language Reference.
(*7) For details, refer to EPSON RC+ 7.0 Online Help or MCal in SPEL
+
Language Reference.
(*8) This is for experienced users only. Make sure that you fully understand the input specification before
using.
CmdRunning output and CmdError output will not change for this input.
“NoEmgAbort task” will not stop by this input.
When the input changes from ON to OFF, all tasks and commands will stop.
(*9) This function changes the output condition of MotorsOn, AtHome, PowerHigh, and MCalReqd.
By setting this signal with the condition selected using SelRobot1 - SelRobot16, you can switch the output
condition.
Once you select the condition, it will be kept until you change it or turn off / restart the Controller. All
manipulators are selected as default.

Epson VT6L Specifications

General

Brand	Epson
Model	VT6L
Category	Robotics
Language	English