Ericsson EDA 2530 - Page 128

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
128 (200)
f. Now select the “Action” tab.
g. In the “ToDo” column, set all entries to “create”, as follows:-
Double click on the 1
st
entry in this column and from the drop-down list
select the “create” option. Select the 1
st
entry, then left-click & drag down to
the bottom of the column to highlight all entries. Right click & select
“Replicate cell”, all entries in this column should now be set to “create”.
h. Select “Apply All” from the bottom LHS of the screen. Wait until all the
rows turn Green.
i. Select “Read Network” near the top of the screen, this will confirm the
configuration.
j. Select the “RTP Profiles” tab, there will be 11 profiles created the 1
st
is a
default. Entries 2 to 11 are for the ten POTS card positions.
Refer to the following figure.