EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
144 (200)
Select the 1st entry in this column then right click & select the “Unblock”
option from the drop-down list. Select the 1st entry, then click & drag down
to the bottom of the column to highlight all entries. Right click & select
“replicate cell”, all entries in the column should now be set to “Unblock”.
p. Select the “Application Control” tab again.
q. Under the “Command” column, set all entries (64 per POTS card) to
“setAdmin”.
In the “Command” column, in the 1
st
entry double click the empty field and
select the “setAdmin” option from the drop-down list. Select the 1
st
entry,
then click & drag down to the bottom to highlight all entries. Right click &
select “Replicate cell”, all entries in the “Command” column will now be
set to “setAdmin”.
r. Select “Apply All” and all entries should turn green.
s. Check there are 64 entries for each POTS card.
t. Now select “Read Network”.
u. When all entries have been stored, refer back to the “Termination” tab and
the admin status for all entries should now be “unblock”.
7.17.9.3 Complete H248 Virtual Gateway Configuration
a. Whilst still in the “VoIP Management” window select the “H248 Virtual
Gateways” button, at the top left-hand corner of the screen.
b. Select the “Application Control” tab.
c. Under the “Admin Status” column, set all entries to “inService”.
Select the 1
st
entry in this column then right click & select the “inService”
option from the drop-down list. Repeat for each entry, ie there is one entry
for each installed POTS card. All entries in the “Admin Status” column
should now be set to “inService”.
d. Under the “Command” column, set all entries to “setAdmin”.
Select the 1
st
entry in this column then right click & select the “setAdmin”
option from the drop-down list. Repeat for each entry, ie there is one entry
for each installed POTS card. All entries in the “Command” column should
now be set to “setAdmin”.
e. Select “Apply All” and all entries should turn green.
To Next Page
Loading...