EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
195 (200)
Sec 5.2; Changed the boot delay from 3 to 5 sec.
Sec 5.6; Changed CP-IP s/w release from R3B17 to R3C01.
Sec 6 steps c. & f; R4.21 GA PC1 s/w files to be stored in sub-directory
under tftp.
Sec 7.11; Added step d. to set all entries in “Command” column to “modify”
before Applying all Rows.
C 28-02-2009 Third Issue changes.
Sec 3.5; “Local Craft Terminal (LCT) Installation” – rewritten to reflect LCT
release 07.02.06, when installed from CD ROM.
Sec 5.6; Updated CP card’s “Software and Hardware Inventory” screen for
R3C01 build.
Sec 6; Updated “System Software Download” screen for R3C01 build.
Sec 8.3; “Set Equipment Time and Date” - New sub-section added.
D 17-03-2009 Fourth Issue changes, to add POTS card configuration.
Sec 3.5.4; Added a new sub-section called “LCT 07.02.05 – Known Issue
with Java Version 1.6”.
With LCT 07.02.05 there is a known Issue with Java Version 1.6. The
issue is with the National Mapping Tool & setting up the repository location
when Java version 1.6 has been installed. To correct this issue the
commissioning engineer must remove Java 1.6, the LCT, & all of the LCT
packages, then re-install them again but with Java version 1.5 before
attempting to configure any POTS card(s).
Sec 7; Renamed section to “Configure IP and Ethernet Management”.
Sec 7.13; New section added “Configure POTS Cards”, which has eight
sub-sections:-
Sec 7.13.1; “Step 1: LCT 07.02.05 – Known Issue with Java Version 1.6”
Sec 7.13.2; “Step 2: Add POTS Card(s) Interface VLANs to Static VLANs”
Sec 7.13.3; “Step 3: Configure UK National Mapping”
Sec 7.13.4; “Step 4: Configure ITAM For Double Play”
Sec 7.13.5; “Step 5: Configure RTP Profiles”
Sec 7.13.6; “Step 6: Check TOIP Profiles”
To Next Page
Loading...