Ericsson EDA 2530 - Page 92

EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
© Ericsson AB 2010
Commercial in confidence
92 (200)
d. Click on the “Accept selected entries” button, the display will revert back
to the main Static VLAN table.
e. Against the highlighted “ethG//1/1/3” entry in the table, under the
Command column right-click to select “addPort” from the drop-down list of
options.
f. Select “Apply All” to add the new entry.
g. Select “Read Network” to confirm the updated configuration, the following
screen shows the newly created VOIP_GW1 “ethG//1/1/3” entry.
h. Repeat steps a to g to add the VOIP_GW2 S-VLAN Name entry for
“ethG//1/1/3” in the Static VLAN table.
i. Repeat steps a to g to add the VOIP_GW3 S-VLAN Name entry for
“ethG//1/1/3” in the Static VLAN table.
j. Repeat steps a to g to add the VOIP_GW4 S-VLAN Name entry for
“ethG//1/1/3” in the Static VLAN table.
i. Repeat steps a to g to add the VOIP_GW5 S-VLAN Name entry for
“ethG//1/1/3” in the Static VLAN table.
j. Repeat steps a to g to add the VOIP_GW6 S-VLAN Name entry for
“ethG//1/1/3” in the Static VLAN table.