-- 61 --
2sxx02cw
Water connection
The Aristo
TM
/Origo
TM
Feed has a sensor ELP, ESAB Logic Pump, that senses if the
water hoses of the welding gun are connected. When a water cooled welding gun is
connected, the water pump starts.
When connecting the cooling water hoses to/from the Feed wire feed unit, the mains
ON/OFF switch of the Mig must be in the OFF position.
Note, if a water cooled welding gun is used when the pump is inactive, the welding
gun might be damaged, therefore it is not recommended to use wire feeders not
equipped with ELP.
Water flow guard
The water flow guard interrupts the welding current in the event of loss of coolant
and an orange indicating lamp on the front of the power source lights up.
The water flow guard is an accessory. Ordering number see in user manual.
MAINTENANCE
Regular maintenance is important for safe, reliable operation.
Maintenance must be executed by a professional.
Only those persons who have appropriate electrical knowledge (authorised
personnel) may remove the safety plates.
Note!
All guarantee undertakings from the supplier cease to apply if the customer himself
attempts any work in the product during the guarantee period in order to rectify any
faults.
Inspection and cleaning
Check regularly that the power source is free from dirt.
The power source should be regularly blown clean using dry compressed air at
reduced pressure. More frequently in dirty environments.
Otherwise the air inlet/outlet may become blocked and cause overheating. To avoid
this you can use an airfilter.
The airfilter is an accessory. Ordering number in user manual.
Topping up the coolant
ESAB ready mixed coolant is recommended for use. See accessories in user
manual.
S Fill with coolant.
(The fluid level must not exceed the upper marking but neither must it be below
the lower marking).
To Next Page