Escient FireBall E-120 - Page 218

PAGE 218
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX I - WIRELESS KEYBOARD
Programming the Keyboard to Control an Escient TuneBase
The Escient wireless keyboard can be programmed to control not only the FireBall but
also the Escient TuneBase. Follow these instructions carefully, to program the keyboard
for the Escient TuneBase.
1) Press and Hold the “SET” button until the red LED ashes twice.
2) Slowly enter “997”. The red LED should ash twice.
3) Press the blue “CH-” key on the left side of the keyboard until the red LED ashes
four times.
4) Press the ‘swoop’ button (the one just to the right of the POWER button).
5) Press and Hold the “SET” button until the red LED ashes twice.
6) Slowly enter “1162”.
The wireless keyboard should now control the Escient TuneBase.