Escient FireBall E-120 - Programming the Keyboard to Control an Escient FireBall

PAGE 219
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX I - WIRELESS KEYBOARD
Programming the Keyboard to Control an Escient FireBall
Follow these instructions carefully, to re-program the keyboard for the Escient FireBall
1) Press and Hold the “SET” button until the red LED ashes twice.
2) Slowly enter “997”. The red LED should ash twice.
3) Press the blue “CH-” key on the left side of the keyboard until the red LED ashes
four times.
4) Press the ‘swoop’ button (the one just to the right of the POWER button).
5) Press and Hold the “SET” button until the red LED ashes twice.
6) Slowly enter “1163”.
The wireless keyboard should now control the Escient FireBall.