ESTUN AUTOMATION Proprietary
System Status Description
Run
When the system is working, this status is displayed.
When you press STOP key on the operation panel, the machine stops and the
system status is switched to Idle.
If the Count Mode is set to Cnt Down, when the counting has been finished,
(Stock is 0), the machine stops and the system status is switched to Idle.
When any problem doesn’t meet the device settings or prevents normal operation
is detected, the machines stops and the system status is switched to Alarm.
Alarm
When any problem doesn’t meet the device settings or prevents normal operation is
detected, the status is displayed.
Follow the section Appendix D Alarm List, solving the fault according to the fault
message, and then move the cursor on Clear, and press ENTER key, so that the
system can try to reset.
Operation Mode: displayed the current operation mode. There are three operation modes, as
shown in Table 2-2.
Table 2-2 The description of the operation mode
Operation Mode Description
Single
Switch the operation mode to Single, and the parameter Automatic to Disable,
this operation mode is displayed on the page.
In this operation mode, you shall change step by stepping on the foot switch
(Pedal Signal) when the previous step has been finished.
JOG Switch the operation mode to JOG, this operation mode is displayed on the page.
Continue
Switch the operation mode to Single, and the parameter Automatic to Enable,
this operation mode is displayed on the page.
In this operation mode, the system can change step automatically when the
previous step has been finished.
Axis Position
This area displays the current position value of the axes.
In general, the default issued E300 device is the standard version,
which only supports the control of X-axis and Y-axis.
For the more features, you can contact ESTUN.
To Next Page
Loading...
Need help?
General
