Estun E-Series - Page 19

E300 Operation Manual
Programming
Document Version: V1.01
ESTUN AUTOMATION Proprietary
2-8
Multi: SAMPLE Idle Single
Single Multi Manual Die Program Constant
Range [
0 ,
30
] 12
: 00
BN
Angle
X-
axis
Retract
*
Y-
axis
Corr.α Corr.X
1
0.00
0.00
0.00 0.00
0.000
0.000
2
3
4
5
1 0.100 1 1 0.01 0.01 0.00
Y: 0.00 X: 0.00
CP: 1
Figure 2-4 The Multi-Step page
Table 2-5 lists the description of the parameter on this page. You can refer to this table when you edit
the parameters on this page.
Table 2-5 The description of the parameter on Multi-Step page
Parameter Description
Default
1
Range
0 to 30
Unit
－
Description
Set a desired die ID for the program. T
he parameters of the die can be edited
on Die page.
Default
0
Range
0.000 to 99.999
Unit
mm
Description
The thickness of the sheet.
Default
1
Range
1 to 6
Unit
－
Description
Set a desired material ID for the program, which is used for calculat
ing the
bending depth. The parameters of the material can be edited on
Material
Table page.
Default
0
Range
-1 to 999 999
Unit
－
Description
The stock counter is incremented or decremented af
ter each end of a program
cycle, which depends on the settings of the parameter Count Mode.
Set it to -1, indicating the stock count is disabled.
Set it to other value:
When the Count Mode is Cnt Down, the stock counter in production mode
is
decrease
d by 1 after each product cycle. When the counter has reached 0, the
machine is stopped.
When the Count Mode is Cnt Up, the stock counter in production
mode is
increased by 1 after each product cycle.