Estun E-Series - Page 20

E300 Operation Manual
Programming
Document Version: V1.01
ESTUN AUTOMATION Proprietary
2-9
Parameter Description
Default
0
Range
0.00 to 99.99
Unit
s
Description
The wait time before the X-axis performs the retract.
Default
0
Range
0.00 to 99.99
Unit
s
Description
The hold (dwell) time of punch at the bending point.
Default
0
Range
-90.00 to 90.00
Unit
°
Description
This parameter
is valid when the bending method is angle, which indicates the
correction on angle to the whole bending. For example:
If the programmed value is 90, while the actual measured value is 92, then
this parameter shall be set to -2.
If the programmed value is
90, while the actual measured value is 88, then
this parameter shall be set to 2.
BN
Default
1
Range
1 to 25
Unit
－
Description
This parameter indicates the current bending step in the program.
Angle
Default
0
Range
0.00 to 180.00
Unit
°
Description
Set a desired angle value in the selected bending step.
X-axis
Default
0
Range
0.000 to 9 999.999
Unit
mm
Description
The programmed value for the X-axis.
Retract
Default
0
Range
0.000 to 9 999.999
Unit
mm
Description
Retract
distance of the selected axis in the current bend. The "backgauge
retract" is started when the beam is pinching the sheet.
Open
Default
0
Range
0.00 to 99.99 or 0.000 to 9 999.999
Unit
s or mm
Description
Set the opening distance or opening time for the opening process.
Y-axis
Default
0
Range
0.000 to 9 999.999
Unit
mm
Description
The programmed value for the Y-axis.