ETC Sensor3 CEM3 - Fuses; Upgrading Firmware

PhaseAdept Dimmer 75
Fuses
The PhaseAdept module has two user-serviceable fuses. See the illustration below for fuse locations.
Upgrading Firmware
Upgrade firmware for the internal dimming engine using the front panel microUSB port. To access the
microUSB port, remove the screw securing the minimum scale dial and microUSB port cover. See
Configuring Local Mode on page 72 . Firmware can be upgraded using ETC UpdaterAtor software
while the module is uninstalled or installed; powered on or powered off.
Module
Name
Module Part
Number
Fuse
(Qty) Description
Fuse
Part
Number
LED10 7050A1296 (2) 600 V, 20 A, Class G F106
LED10NJ 7050A1297 (2) 600 V, 20 A, Class G F106
LED10RJ 7050A1298 (2) 600 V, 20 A, Class G F106
ELED6 7070A1426 (2) 400 V, 32 A, Type gG F211
ELED6N 7070A1428 (2) 400 V, 32 A, Type gG F211
ELED6R 7070A1427 (2) 400 V, 32 A, Type gG F211
HLED6D2 7070A1429 (2) 400 V, 32 A, Type gG F211
LED10 7183A1209 (2) 600 V, 20 A, Class G F106
ALED5 7183A1210 (2) 600 V, 20 A, Class G F106
Note:
Updating the PhaseAdept module firmware does not update the enclosure control
processor software.
Fuses
Phase Adept Module Top View