12 CEM3 User Manual
Test
Field Description
Set Local Levels
Set levels for outputs from this rack only. This will present a table-style view
of the outputs in this rack and allow setting and releasing of levels. To set
levels:
• Select a circuit by numeric entry or scrolling with the wheel
• To select a range of circuits, use [thru] and [and].
-Press [Last/A] or [Next/B] on the keypad to set a level for the A or B
side of dimmer doubled circuits. See example below.
•Press [at].
• Use numeric entry or scroll to select a level. 0–100 is the valid range.
100 will display as "FL".
•Press [Enter]. The selected circuits will be set to the specified level or
released if you did not enter a level.
Set System Levels
Set levels for chosen circuits in a space. See
Example
on the next page. If
necessary, double press [Back] to clear the command line during any of the
following steps.
1: Use the keypad to enter a circuit number between 1 and 99999.
2: Press [and] to enter multiple circuits or press [thru] to enter a range of
circuits.
• Press [Last/A] or [Next/B] on the keypad to set a level for the A or B
side of dimmer doubled circuits. See example below.
3: Press [at] or [Enter]. The command line ends with "at".
4: Use the keypad or scroll wheel to enter a level if desired. 0–100 is the
valid range. 100 will display as "FL".
5: Press [Enter]. The selected circuits will be set to the specified level or
released if you did not enter a level. The command line ends with "*".
6: If you selected a single circuit, press [Next] or [Last] on the keypad to
increment or decrement the circuit number to set the level of another
circuit, if desired.
Dimmer Check
Quickly run through all lugs or all circuits in a space to test their output at a
given percentage.
Release Systm Lvls Release any active levels for a given space at once.
Presets Record or play back presets. See
Recording and Playing Presets
on
page 27
.
Sequences
Record or play back sequences. See
Recording and Playing Sequences
on
page 29
.
Release All Arch
Release all architectural control such as presets, sequences, and set zone
levels.
Record Rig Check
Record a rig check preset to facilitate AF reporting. Rig Check features are
only available if the rack property AF Enabled is set to Yes. See
Rig Check
on
page 10
,
Advanced Features (AF)
on
page 6
, and
Rack Property
Definitions
on
page 20
for more information.
Run Rig Check
Run a rig check preset. You will be notified of any load inconsistencies
found during the rig check.
Clear Rig Check Clear the recorded rig check from all racks for a given space.
To Next Page
Loading...
