X20/X20S and Ethos v1.5.0 User Manual
Phase One: Registration
Register
1. If your receiver has not yet been registered, initiate the registration process by
selecting [Register]. Otherwise, skip down to the Bind section.
A message box with 'Waiting for receiver...' will pop up with a repeating ‘Register’
voice alert.
2. While holding down the bind button, power up the receiver, and wait for the red &
green LEDs to become active.
The 'Waiting for receiver..' message changes to ‘Receiver Connected’, and Rx Name
field will be filled in automatically.
3. At this stage the Registration ID and UID can be set: