X20/X20S and Ethos v1.5.0 User Manual
4. How to create a model for SR8/SR10
The wizards use the channel order as defined in System / Sticks, by default AETR. However,
for models with more than one surface for ailerons, elevator, rudder, flaps etc the wizard
will normally group these surfaces, so for example you would get AAETR if using 2 Aileron
channels.
The SRx receivers expect a channel order of AETRA, so the wizard can be told (in System /
Sticks) to keep the 'First four channels fixed':
Step 1. Confirm the default channel order
In System / Sticks, confirm that the default channel order is AETR.
Step 2. Enable 'First four channels fixed'
In System / Sticks, enable the 'First four channels fixed' setting. This will ensure that the
wizard does not group similar channels (within the first four) and keep for example both
Aileron channels together.
Step 3. Create the model using the wizard
Run the new model creation wizard by clicking on the [+] in Model / Select Model, and
tell the wizard all the channels your are using. The first 5 channels will be AETRA.
Notes
Please note that Self Check for Archer receivers is now performed via the System /
Device Config / SxR tool. The Archer receiver firmware must be v2.1.10 or higher.
Note that the throttle channel 3 must be at -100 or the Self Check will not be initiated.
To Next Page
Loading...
Need help?
General