Ethos X18 Series User Manual

X20/X20S and Ethos v1.5.0 User Manual
Device config
‘Device config’ contains tools for configuring devices like sensors, receivers, the gas suite,
servos and video transmitters.
The following devices are currently supported:
 Airspeed
 Current
 SBEC
 Gas Suite
 GPS
 Lipo Voltage
 RB 30/40
 RPM
 SxR
 SxR Calibration
 Variometer
 VS600 video transmitter
 XAct servos
 Pressure
 Temperature
 Remote NFC switch
Please refer to the device's manual for further details.
Please note that the ETHOS ‘Device config’ screen lets you change S.Port sensor Physical IDs
and Application IDs. If you have more than one device that have the same function, you would
need to connect them one at a time, discover them in Telemetry / ‘Discover new sensors’, then
in ‘Device config’ change the Physical ID and Application ID, and then go back and rediscover
them with the new ID. Please refer to the SmartPort Telemetry section.
50 rev 4

Ethos X18 Series Specifications

General

Number of Channels	18
Touch Screen	Yes
Telemetry	Yes
Internal RF Module	Yes
Haptic Feedback	Yes
Voice Prompts	Yes
Operating Voltage Range	8.4V
Gimbal Type	Hall Effect
Connectivity	Bluetooth
Ports	USB-C
Battery	2S Li-battery