Euromag MC608 Series Installation Manual

fig_92_1
fig_92_2
fig_92_4
fig_92_3
39
IrCOM port
MC608 configuration is made via PC using the
Euromag MC608 software program.
- Use an USB adapter for direct communication to
PC (available at the manufacturer on request) or
an infra-red interface unit.
MC608B or MC608R:
- Install the MC608 software on the PC, start the
program, connect the unit to the PC and activate
it with the magnet sliding it laterally on the front,
at the “activate”. Select RS485 or infra-red
communications, and press the CONNECT button
(see below the screen of the MC608 program).
MC608A:
- Install the MC608 software on the PC, start the
program and connect the unit to the PC. Select
RS485 or infra-red communications and press
the CONNECT button (see below the screen of the
MC608 program).
magnetic key (only
supplied with
MC608B and
MC608R)
9. CONVERTER MC 608
IrCOM cable
USB - MODBUS cable

Euromag MC608 Series Specifications

General

Brand	Euromag
Model	MC608 Series
Category	Media Converter
Language	English