2
7
8
1
+
+
-
-
24V
mA
SOURCE
MC608
fig_914_10
37
CONNECT ONLY ONE OUTPUT AT A TIME WITH INTERNAL POWER SUPPLY
(7-8) AUX MAX 30 MA
NOTE
Active (MC608 version 6.3 and
subsequent)
The connected 4-20mA receiver is a passive
milliamp-meter; the internal MC608 24Vdc power
supply must be connected as shown.
(24VDC loop voltage of 24Vdc, maximum
impedance 800 ohm)
9.1.6 ELECTRICAL GROUNDING OF THE
CONVERTER CASE
The MC608 case should be grounded. This
connection should be carried out by grounding the
bolt located in the lower part of the converter.
MAKING A PROPER CONNECTION
IS NECESSARY FOR AN EFFICIENT
OPERATION OF THE DEVICE.
NOTE
THE RS485 OUTPUT IS A MODBUS
STANDARD COMMUNICATION PORT,
COMPATIBLE WITH ANY SOFTWARE
THAT IS ABLE TO COMMUNICATE IN
MODBUS, FOR MORE INFORMATION
PLEASE REFER TO THE MODBUS
MANUAL.
NOTE
9.1.5 RS485 MODBUS Output
The standard RS485 interface is available between
terminals 13 - 14 -15 as shown in fig_914_1.
MC608B OR MC608R CONVERTERS
ARE EQUIPPED WITH PULSE OUTPUT
AND THE 4..20m OUTPUT ONLY IN
LOOP MODE
NOTE
9. CONVERTER MC 608
To Next Page
Loading...
Need help?
General
