38
EUROMAG | MC608 | TD210-1
www.euromag.com
9.1.7 CONNECTION TO THE POWER
SUPPLY
ELECTRICAL CONNECTION OF THE
DEVICE MUST BE CARRIED OUT BY
PROPERLY TRAINED SPECIALISTS
CAUTION!
Make sure all electrical connections are
correctly performed before connecting the unit to
the power supply. Check the power voltage on the
name plate.
The unit may be supplied with voltage:
MC608A
90 … 264 Vac
O 12 … 24 Vac/dc
MC608B
Powered by lithium battery
O 12 … 24 Vac/dc
MC608R
Powered by a rechargeable lithium battery
O 12 … 24 Vac/dc
Power supply and battery charging is supplied by
the solar panel
9.2 PROGRAMMING THE MC608
CONVERTER
MC608 configuration can be performed in different
ways:
• Through the 4 push buttons located on the front
display of the converter, unscrewing the front
panel glass
• Via PC through the RS485 MODBUS
output (see electrical connections) and the
configuration software program Euromag
MC608. The USB cable adapter is available at
the manufacturer’s on request.
• From the PC via the infra-red port located on
the front of the converter, above the display and
the Euromag software configuration program
MC608
The Euromag MC608 software can be downloaded
via www.euromag.com visiting the download area,
or it can be ordered on CD.
Activation of the MC608B or MC608R in
battery mode
Normal operation of the MC608B is “sleep
mode”. This mode preserves battery life while
ensuring the functional operation of the product.
To recall the unit for next programming or value
reading on the display, use the supplied magnetic
swipe and slide it vertically on the front panel of the
converter, suitably marked: “activate”
To Next Page
Loading...
Need help?
General
