Euronda Pro System E8 - Technical Data and Noise

E8_Aus_rev07 – 2021-02-02
16
5.3 TECHNICAL DATA AND NOISE
CHARACTERISTICS
E8 24L
Power supply voltage
230 V
Mains frequency
50 / 60 Hz
Power output
2300 W
Absorbed current
10 A
Insulation class
I
Protection class
IPX0
Sterilisation cycles
3 sterilisation cycles
Control cycles
Vacuum test - Bowie & Dick test - Helix test
Personal Functions
2 LIGHT* cycles (N134, N121), 2 LIGHT & STOCK* cycles (S134, S121), 2
NGV cycles
*to enable the Personal Functions complete the registration in the
www.euronda.com/myeuronda portal
Additional test cycles
Pressure hold - activation of safety valve
Range of environmental
conditions in which the unit
was designed to operate
- Indoor use
- Altitude up to 2,000 m a.s.l.
- Temperature: +5 - +40°C
- Max. relative humidity 85%
- Max variation in mains voltage: ±10%
- Installation category (overvoltage category) II
- Degree of pollution: 2
Maximum pressure *
250 kPa (2.5 bar)
Dimensions of sterilisation
chamber
Diameter: 250 mm
Depth: 440 mm
Usable space** of chamber
180 x 160 x 380 mm (LxHxD)
11 litres
Usable capacity of chamber
Capacity of water tanks
4 litres
Weight for support area (full
tank and chamber with
maximum weight)
3,21 kg/cm2 (315384N/m2)
Operation control
Microprocessor
Printer
Optional (thermal printer, labels)
Bacteriological filter
Yes
* Note: in this manual, the word “pressure” always refers to “relative pressure”.
**Usable space
This is the internal capacity of the sterilization chamber available for material to sterilize (fig. 5.3-1).