E8_Aus_rev07 – 2021-02-02
7.4.2 Manually stopping a cycle after the sterilization phase
If a cycle is stopped after completion of the sterilisation phase but before the end of the drying phase, the
load in the boiler is to be considered as STERILE BUT WET. As the load has not been dried correctly, it is
not possible to preserve it and it must therefore be considered as being for IMMEDIATE USE. The sterile but
wet load screen appears on the display. The door is locked. Touch the middle button to release it.
7.5 POWER BLACKOUTS
Power cuts may occur during the operation of the unit, caused by the electricity provider. In this case, the
E02 alarm message appears (see “Appendix 9 “Troubleshooting”).
7.6 RESETTING THE UNIT AFTER AN INTERRUPTION CAUSED BY AN ALARM
To recover the unit after an interruption caused by an alarm, touch the screen to release the door and return
to the Home screen. For further information, consult “Appendix 9 Troubleshooting”.
To Next Page
Loading...
