E8_Aus_rev07 – 2021-02-02
CHAPTER 10
10.1 INSTRUCTIONS FOR DISPOSAL
The E8 unit has been manufactured using ferrous materials, electrical components and plastics. To scrap
the unit, separate the various components according to the material they are made of in order to simplify
reuse or differentiated disposal.
No particular operations are required after scrapping.
Do not dump the unit.
Take it to a disposal company.
Always refer to the specific laws in the country of use when scrapping and disposing of the appliance.
The symbol on the appliance means that it must be disposed of as “sorted waste”.
The user must therefore send (or instruct other people to send) the unit to one of the sorted waste collection
centres set up by the local councils, or send it to the dealer against the purchase of an equivalent unit
(European Union only).
Sorted waste collection and the subsequent treatment, recovery and disposal operations facilitate the
production of equipment using recycled materials and limit the negative environmental and health effects that
may be caused by improper waste management.
Abusive dumping by the user will be punished according to law.
10.2 RESALE
If the unit is sold, hand over all the technical documentation to the new purchaser, inform him/her about any
repair work carried out and how to use and service the unit.
Also inform Euronda S.p.A. of the sale and provide it with data about the new purchaser.
To Next Page
Loading...
