Euronda Pro System E8 - Appendix 5; Description of Programs

E8_Aus_rev07 – 2021-02-02
60
APPENDIX 5
Description of programs
The E8 unit can perform three sterilization cycles; the parameters of each cycle are summarised in the table
below:
Cycle
Parameters
B134
B121
B134 RAPIDO
E8 24L
E8 24L
E8 24L
Temperature
134°C
121°C
134°C
Pressure
2.05 bar
1.05 bar
2.05 bar
Length of sterilization phase
(plateau period)
4’
20’
3.5’ / 18
Drying time (Auto)
15’
15’
5’
Maximum load (solid/porous)
6 - 2 kg
6 - 2 kg
0.6kg – 0.2 kg
The cycle profile may vary from one software version to another.
Fractioned preliminary
vacuum
V1
1st vacuum
P1
1st pressure rise
V2
2nd vacuum
P2
2nd pressure rise
V3
3rd vacuum
P3
3rd pressure rise
Sterilization phase
STS
Start of sterilization period
STE
End of sterilization period
Drying
D1
Start of drying phase
D2
End of swift drying phase
D3
Start of common drying phase
DE
End of common drying phase
The symbols (2b, 3c, etc.) after the code of the phase refer to the software instructions.
The various sterilisation cycles are now described one by one: as they are all B-type cycles, they can
sterilise any type of load, whether it be porous, solid or hollow. In all cases, the recommendations given
Sterilization phase
Drying phase
Fractioned preliminary vacuum