E8_Aus_rev07 – 2021-02-02
Before starting the selected cycle, load the material to sterilize into the unit:
1. Open the door (Fig. 7.1-1).
2. Place the trays with the material to sterilise inside the unit.
In order to load the material to sterilize correctly, carefully read all the instructions given in
Appendix 1 “Preparing the instruments for sterilization”, Appendix 2 “Packaging” and
Appendix 3 “Arranging the load”.
3. Close the door: pull the handle towards you while pushing the door in, and then turn the handle back
towards the unit.
4. Select the cycle type following the instructions given in chap. 7.2.
To Next Page
Loading...
