Eventide harmonizer H8000

To Next Page

To Previous Page

The Harmonizer

Programmer’s Manual

Resolution

The resolution specifier controls what minimum change in a parameter value can be achieved by

turning the KNOB or by using the INC or DEC key on the numeric keypad. The resolution parameter

also controls the “rate of change” as the KNOB is spun. If the resolution is very fine, the parameter

value will increment in “baby steps” as the

KNOB is spun. If the resolution is very course, the

parameter value will increment in “great leaps” as the KNOB is spun.

For example, if the selected parameter displays a value of

45.30 and the resolution is 1.0000, then

slow motion clockwise rotation on the KNOB will change the value to 46.30 (unless the

max value

is less

than

46.30

!). If the selected parameter displays a value of 45.30 and the resolution is 0.1000, then slow

motion clockwise rotation on the KNOB will change the value to 45.40.

As yet another wee exercise, use the <modify> SOFT KEY the same way as in the Min and Max Value

section and adjust the resolution specifier of the knb module. Notice the difference this makes in the

“step size” of the

Each Delay parameter value. (You’ll have to walk yourself through this one. . .)

Eventide harmonizer H8000 - Page 88