evertz 5700ACO - AES DARS Faults*

5700ACO
Automatic Changeover
Page 34 Revision 1.0
4.6.1. Network Configuration
1) Network Configuration - set the IP parameters for this 5700ACO
ip address: 192.168.1.200
netmask address: 255.255.255.0
gateway: 0.0.0.0
broadcast address: 192.168.1.255
DHCP enabled: False
----------------------------------
(1) Set IP Address
(2) Set Netmask
(3) Set Gateway
(4) Set Broadcast Address
(5) Use DHCP
(6) Enable Ethernet
(S) Save and exit
(X) Exit without saving
4.6.2. SNMP Configuration
2) SNMP Configuration – set the TRAP destination IP address which originate at this 5700ACO
(if enabled)
---------------------------------------------------
Trap Destination 1: 192.168.1.88
---------------------------------------------------
(1) Set Trap IP Address
(2) Remove Trap IP Address
(S) Save and exit
(X) Exit without saving