evertz 5700ACO - LTC Faults; MSC GPO Faults; Figure 5-7: Vistalink; Figure 5-8: Vistalink

5700ACO
Automatic Changeover
Revision 1.0 Page 45
5.6.3. LTC Faults
The LTC Faults section, as illustrated in Figure
5-7, allows the user to enable LTC traps and monitor
the trap status.
Figure
5-7 : VistaLINK
®
– LTC Faults
To enable a particular trap, simply click the box located beside each trap so that a
check-mark appears. When a check-mark is present, the SNMP trap is enabled. When a check-mark is
not present, the trap is disabled.
The LTC Fault Status section displays whether a fault is active or not. If the box is green, then the
corresponding fault is not active. If the box is red, then the corresponding fault is active.
* Requires factory installed +AUX hardware option on 5700MSC-IP, IP Master Clocks are available at
extra cost.
5.6.4. MSC GPO Faults
This section, as illustrated in Figure
5-8, allows the user to enable MSC GPO traps and monitor the trap
status.
Figure
5-8 : VistaLINK
®
– MSC GPO Faults