5700ACO
Automatic Changeover
Page 36 Revision 1.0
4.6.4. Show Status
(4) Show Status – shows a synopsis of all of the above 3 items, and also shows the status of all input
channels. There are no settable controls under this menu item.
Software V1.0 34
Trap destinations
----------------------------------
Community Strings
Read-Only: |public|
Read-Write: |private|
----------------------------------
IP address: 192.168.8.98
netmask address: 255.255.255.0
gateway: 192.168.8.10
broadcast address: 192.168.8.255
DHCP enabled: False
Ethernet: enabled
----------------------------------
In voting, I = included, E = excluded.
Individual channel voting enabled.
Sync 1 = I. Sync 2 = I. Sync 3 = I. Sync 4 = I. Sync 5 = I. Sync 6 = I.
LTC 1 = I. LTC 2 = I. GPO 1 = I. GPO 2 = I.
Word Clock = I. Ten MHz = I.
Balanced AES 1 = I. Balanced AES 2 = I. Balanced DARS = I.
Unbalanced AES 1 = I. Unbalanced AES 2 = I. Unbalanced AES 3 = I. Unbalanced DARS = I.
----------------------------------
Input status. A = present on input A, a = not present on input A
B = present on input B, b = not present on input B
Sync 1 = abSync 2 = abSync 3 = ab
Sync 4 = abSync 5 = abSync 6 = ab
LTC 1 = abLTC 2 = abGPO 1 = ABGPO 2 = AB
Ten MHz = abWord Clock = ab
Balanced AES1 = ab Balanced AES2 = ab Balanced DARS = ab
Unbalanced AES1 = abUnbalanced AES2 = abUnbalanced AES3 = abUnbalanced DARS = ab
Power Supply Left = FAIL. Power Supply Right = OK
Temperatures (deg C): CPU = 31, FPGA = 41, PS Left = 26, PS Right = 25
Fans: Front Left OK Rear Left OK Front Right OK Rear Right OK
Door is Open. Current output selected is B
4.6.5. Upgrade
5) Upgrade – enters an upgrade mode for firmware upgrades. If entered you will be prompted again to
be sure you wish to do an upgrade. See section
4.5.4 above for details on how to complete the
upgrade.
To Next Page
Loading...
