5700ACO
Automatic Changeover
Page 30 Revision 1.0
or STP cable is required. The cable must be “straight through” with a RJ-45 connector at each end.
Make the network connection by plugging one end of the cable into the RJ-45 receptacle of the
5700ACO and the other end into a port of the supporting Ethernet switch.
Connector RJ-45
Function VistaLINK
®
control and status monitoring
4.4.8. Electrical
Power Auto ranging 100 - 240 Volts AC, 50/60 Hz, 80 VA
Configuration Dual redundant supplies
Fuse Rating 250 V, 1 amp, time delay
Safety ETL Listed, complies with EU safety directives
EMI/RFI Complies with FCC Part 15 Class A regulations
Complies with EU EMC directive
4.4.9. Physical
Dimensions 19” W x 3.5” H x 11.5” D
(483mm W x 90mm H x 292mm D)
Weight 16 lbs. (7.0Kg)
4.5. UPGRADING THE FIRMWARE
4.5.1. Overview
The firmware in the 5700ACO is contained on a FLASH EPROM. From time to time firmware updates
will be provided to add additional features to the unit.
The following equipments are needed in order to update the Firmware:
• PC with available communications port. The communication speed is 57600 baud, therefore a
486 PC or better with a 16550 UART based communications port is recommended.
• “Straight-thru” serial extension cable (DB9 female to DB9 male) or (DB25 female to DB9 male).
• Terminal program that is capable of Xmodem file transfer protocol. (such as TeraTerm)
• New firmware supplied by Evertz.
To Next Page
Loading...
