5700ACO
Automatic Changeover
Revision 1.0 Page 41
General
10Mhz voting: If this field is set to include, the 10Mhz input status will be included in the voting
process. If set to exclude, the input will not be included in the process.
Word Clock Voting: If this field is set to include, the word clock input status will be included in the
voting process. If set to exclude, the input will not be included in the process.
Analog Sync Voting
There are six analog sync outputs that can be monitored. For brevity, only Sync 1 will be explained in
the manual.
Sync1: If this field is set to include, the Sync1 inputs will be monitored for presence. If set to exclude,
these inputs will not be included in the process.
DARS Voting
For brevity, only Balanced AES 1 and Balanced Dars will be discussed in the manual.
Balanced AES1: If this field is set to include, Balanced AES1 will be included in the voting process. If
set to exclude, the signal will not be included in the process.
Balanced DARS: If this field is set to include, Balanced DARS will be included in the voting process. If
set to exclude, the signal will not be included in the process.
LTC Voting
For brevity, only LTC 1 will be discussed in the manual.
LTC1: If this field is set to include, LTC1 will be included in the voting process. If set to exclude, the
input will not be included in the process.
GPO Voting
For brevity, only Channel 1 (GPO 1) will be discussed in the manual.
Channel 1: If this field is set to include, Channel 1 will be included in the voting process. If set to
exclude, the input will not be included in the process.
To Next Page
Loading...
