Before linearity calibration, make sure “Zero calibration” and “Weight Calibration” are properly
performed. Set the calibration switch to ON position.
Press
CAL
key
Choose
Press
key
Press
to next step Press
key to previous step
Press
to next step Press
key to previous step
Enter the correct weight value
Press
to next step
The calibrated weight value
is displayed when the
signal is stable
Press
to next step
After finishing the first linearity calibration,
choose to continue or exit the linearity mode
by pressing
.
◆ Refer to 5-4 Error Messages when any error message appears during the procedure.
5-2-4 Linearity Calibration
Five point linearity calibration.
Choosing from 1P ~ 5P by
pressing
key.
⇒ No linearity
calibration value at this point
⇒ linearity calibration
value present at this point
The weight value is displayed.
⇒ Increase the number of
the flashing digit
⇒ Decrease the number
of the flashing digit
⇒ Shift the flashing digit
one space to left
⇒ Shift the flashing digit
one space to right
⇒ Save the settings
⇒ Exit the settings
To Next Page
Loading...
