Test Setup - Test Configurator, Timer, and System
NetBlazer 149
Interface (Ethernet, Packet Sync, Fibre Channel, and Wireless)
Interface (Ethernet, Packet Sync, Fibre
Channel, and Wireless)
From the Test menu, tap Setup, Test Configurator, the interface block,
and the Interface tab.
LINK
An arrow is used to indicate the status of the test link.
A green arrow indicates that the link is up.
A red arrow indicates alarms, the link is down.
A gray arrow indicates awaiting incoming data to provide a status.
For Ethernet and Packet Sync test applications:
Auto-Negotiation check box is available with 10/100/1000M Electrical
and 1GE Optical interfaces. When the Auto-Negotiation check box is
selected the test application indicates to the remote port which
parameters to use. The Auto-Negotiation check box is automatically
selected for 1GE Electrical interface and is not configurable.
Note: When the Auto-Negotiation check box is selected, the port Speed, Duplex,
Flow Control, and Local Clock parameters can be set. Those settings are
not applied immediately to the port, they are used only when the
negotiation process is started and take effect only when the
auto-negotiation succeeds. However current settings are applied
immediately to the port when the Auto-Negotiation check box is cleared.
To Next Page
Loading...
