EXFO FTB-880 - 3 Getting Started; Turning On the Unit; Starting the FTB-700 G;800 Series Application

NetBlazer 9
3 Getting Started
If the FTB-700G/800 Series has been purchased at the same time as the
FTB-1, the FTB-700G/800 Series module is pre-installed with the
appropriate software version. If the NetBlazer is not already installed, refer
to the FTB-1 User Guide for more information on how to install the module.
Turning On the Unit
Turn on the FTB-1. Refer to the FTB-1 user guide for more information.
Starting the FTB-700G/800 Series Application
The module can be configured and controlled by starting the NetBlazer or
OTDR application; only one application can run at once.
To start the NetBlazer application:
1. For FTB-800 Series, from Mini ToolBox tap the NetBlazer application
button.
2. For FTB-700G Series, from Mini ToolBox select the
FTB-7xx Ethernet & Multi-Service module then tap NetBlazer
application button.
Note: To start the OTDR application, refer to the OTDR or iOLM user guide for
more information.