EXFO FTB-880 - Traffic - OAM, S-OAM, and MPLS-TP OAM

Test Results
NetBlazer 451
Traffic - OAM, S-OAM, and MPLS-TP OAM
Traffic - OAM, S-OAM, and MPLS-TP OAM
From the Test menu, tap Results, Traffic, and the OAM, S-OAM, or
MPLS-TP OAM tab.
Traffic Monitoring
Note: Only available with Carrier Ethernet OAM test application.
 In TX, reports counts of CCM, LBM, LTM, DMM, LMM, SLM, TST, AIS,
LCK, and CSF frames transmitted. LTM and SLM are only available with
Ethernet OAM. Total count is reported as well as unicast and/or
multicast frame counts when applicable.
 In RX, reports counts of CCM, LBR, LTR, DMR, LMR, SLR, TST AIS, LCK,
and CSF frames (LTR and SLR are only available with Ethernet OAM)
received regardless of the sender as long as the following criteria are
met:
 S-OAM: The destination MAC address matches either the local MEP
Unicast MAC address or a Multicast class 1 or class 2 address; and
the VLANs matches the unit port VLANs. Refer to Unicast/Multicast
Addresses for Ethernet OAM on page 638 for more information.
 MPLS-TP OAM: The destination MAC address matches either the
unit MAC address, FF:FF:FF:FF:FF:FF, or 01:00:5E:90:00:00; the
VLANs matches the unit port VLANs; and MPL Labels matches the
local MPLS Label Stack configuration. For AIS, LCK, and CSF, valid
messages must also have the MEG Level matching the Local MEG
Level.
Total count is reported as well as unicast and/or multicast frame counts
when applicable.