EXFO FTB-880 - Summary (EtherSAM)

Test Results
NetBlazer 405
Summary (EtherSAM)
Summary (EtherSAM)
From the Test menu, tap Results, and the Summary tab.
Note: For Dual Test Set, only Start Time is displayed on the remote module.
 Service Configuration/Performance Test Status indicates the actual
test status as follows:
 Start Time indicates the date and time the test has been started. The
date and time is reset every time the test is restarted.
 Remote unit in use and locked for Dual Test Set indicates that this
module is used for Dual Test Set as the remote module.
Test Status Description
“--” Test has not started.
Disabled Test/subtests is/are disabled.
Running Test/subtest is currently running.
Data Transfer Test/subtest is running but no test traffic is being transmitted.
Completed, <Verdict> Test/subtest has completed with the test pass/fail verdict. A
fail verdict is declared when a Link Down or LOS is detected,
or when any SLA parameter fails.
Aborted, <reason> Test/subtest has been aborted either manually (Stop) or
automatically from an alarm and the reason why the test has
been aborted is also displayed as follows:
Link down alarm, LOS alarm, Timeout during execution,
DTS connection failed, Loss of remote connection (DTS),
LOPPS-L Alarm
a
, LOPPS-R Alarm
a
,
LOPPS-L / LOPPS-R Alarm
a
, Unresolved addresses,
No test enabled, Invalid Burst Configuration,
CIR disabled for all services, Excessive Refill Time
b
,
Stopped
a. Available for Dual Test Set in One-Way Latency measurement mode.
b. An excessive refill occurs when the pre-burst and/or post-burst duration last for
more than 2 seconds.