EXFO FTB-880 - Remote Details (iSAM)

Test Setup - Test Configurator, Timer, and System
202 FTB-700G/800 Series
Remote Details (iSAM)
Remote Details (iSAM)
The remote block automatically scan the remote modules for DTS and
Remote Loopback modes and allows the selection of the remote module
that is used to loop back the traffic via Smart Loopback or EtherSAM in
Dual Test Set (DTS) mode for simultaneous bidirectional results. The
number module available for remote connection is displayed. If the
connection with the remote module is not manually established, the
remote connection process is automatically performed when starting the
test.
From the Test menu, tap Setup, Test Configurator, and the More button
from the Remote block.
Note: Not available with Manual Loopback remote operation mode.
For both DTS and Remote Loopback Operation
Modes
 Discovered Remotes
The modules are discovered dynamically and listed with their Name,
IP address, Status, Connection, and Preferred information. Name and
Status are only available for remote FTB-700G/800 Series,
FTB-800v2 Series, and FTB-88000 Series, modules. Only modules from
the same subnet are automatically discovered. To access a module
from a different subnet, use the Add button.