Test Setup - Test Applications
42 FTB-700G/800 Series
iSAM
iSAM
iSAM is a simplified version of EtherSAM that is centered around addressing
turn-up of E-Line circuits (EVC). The objective of the test is to validate
Carrier Ethernet-based services key performance indicators defined in
MEF: Frame Delay (FD), Inter-Frame Delay Variation (IFDV), and Frame
Loss Ratio (FLR). In addition the RFC 6349 subtest can be enabled to
validate that the Ethernet service is able to properly carry TCP traffic.
The iSAM test has to be executed in conjunction with a remote module.
The remote module can be either in loopback configuration for
unidirectional testing or in EtherSAM Dual Test Set mode for bidirectional
testing.
The Dual Test Set test allows bi-directional test between two compatible
modules providing independent results for each test direction. The results
from local-to-remote and remote-to-local are available on the local testing
unit.
Typical iSAM test applications:
Supported Interfaces/Rates: 10M to 10G LAN/WAN.
Network
under test
(EVC)
Local Unit Remote Unit
FTB-700G/800 Series FTB-700G/800 Series
Manual or
Remote
Loopback
Network
under test
(EVC)
Local Unit Remote Unit
FTB-700G/800 Series FTB-700G/800 Series
EtherSAM
(DTS)
To Next Page
Loading...
