EXFO FTB-880 - RFC 2544 - Subtests

Test Setup - Test Configurator, Timer, and System
NetBlazer 209
RFC 2544 - Subtests
RFC 2544 - Subtests
From the Test menu, tap Setup, Test Configurator, tap on the RFC 2544
block. and on the Subtests tab.
Allows the configuration of each enabled subtest.
Throughput
The objective of this test is to find the throughput of the device under test
for which there is no frame loss. Starting at the specified maximum rate
(Max. Rate), the rate converges towards the highest throughput without
frame loss. The search is done with a halving/doubling method until a final
value is reached. The throughput measurement is validated the number of
times specified (Validations) for the predefined duration (Trial Duration).
The Accuracy setting specifies how precise the result must be. The test is
performed for each defined frame size.
 Max. Rate is the maximum rate the test should begin with, in terms of
a percentage of the line rate (%), Mbit/s, or Gbit/s. For Dual Test Set
Max. Rate is configurable for both local to remote (L->R) and remote
to local (R->L) directions.
Interface
Speed
Max. Rate
% Mbit/s Gbit/s
10 Mbit/s 0.0050 to 100.0000
a
a. Default value.
0.00001 to 10.000
a
Not Applicable
100 Mbit/s 0.0050 to 100.0000
a
0.0001 to 100.000
a
Not Applicable
1000 Mbit/s 0.0050 to 100.0000
a
0.001 to 1000.00
a
0.000001 to 1.000
a
10G LAN 0.0050 to 100.0000
a
0.01 to 10000.000
a
0.00001 to 10.000
a
10G WAN
b
b. The maximum value for 10G WAN may be lower depending on the frame size. The
maximum value will be adjusted for each frame size.
0.0005 to 92.8571
a
0.01 to 9285.71
a
0.00001 to 9.28571
a