Test Results
452 FTB-700G/800 Series
Traffic - OAM, S-OAM, and MPLS-TP OAM
Responder
Note: Available when the S-OAM Responder or MPLS-TP OAM Responder check
box is selected (refer to S-OAM and MPLS-TP OAM Responder on
page 221).
For Carrier Ethernet OAM test application:
In TX, reports counts of LBR, LTR, DMR, LMR, and SLR total frames
transmitted. LTR and SLR are only available with Ethernet OAM.
In RX, reports counts of valid LBM, LTM, DMM, LMM, and SLM unicast,
multicast, and total frames received. LTM and SLM are only available
with Ethernet OAM. A valid messages must have its:
S-OAM: source MAC address matching the Peer MEP MAC address;
destination MAC address matching either the unit port Unicast MAC
address or a Multicast class 1 or class 2 address; VLANs matching the
unit port VLANs, and MEG/MD Level matching the local MEG/MD Level.
Refer to Unicast/Multicast Addresses for Ethernet OAM on page 638 for
more information.
MPLS-TP OAM: destination MAC address matching either the unit MAC
address, FF:FF:FF:FF:FF:FF, or 01:00:5E:90:00:00; VLANs matching the
unit port VLANs; and MPL Labels matching the local MPLS Label Stack
configuration.
For Smart Loopback test application:
In TX, reports counts of LBR, LTR, DMR, LMR, and SLR total frames
transmitted.
In RX, reports counts of valid LBM, LTM, DMM, LMM, and SLM total
frames received. A valid messages must have its destination MAC
address matching either the unit port Unicast MAC address or a
Multicast class 1 or class 2 address. Refer to Unicast/Multicast
Addresses for Ethernet OAM on page 638 for more information.
To Next Page
Loading...
