Test Setup - Test Configurator, Timer, and System
NetBlazer 161
Interface (iSAM)
IP
IP Version is set to IPv4.
Automatic IP (DHCP) check box, when selected (cleared by default),
allows to dynamically obtain an IP address from a DHCP (Dynamic
Host Configuration Protocol) server.
Note: IP Address, Subnet Mask, and Default Gateway are not available when
the Automatic IP (DHCP) check box is selected.
IP Address allows to enter the source IP address for the stream. The
default setting is 10.10.x.y, where x and y are respectively the two least
significant bytes of the port default MAC address.
Subnet Mask allows to enter the Subnet Mask for the stream. The
default setting is 255.255.0.0.
Default Gateway check box, when selected (cleared by default),
allows to enter a default Gateway IP address. When the Default
Gateway check box is selected, its default address is 0.0.0.0.
Remote Discovery ID
Remote Discovery ID is used to easily identify this module in case another
module is performing a discovery scan. Up to 16 alpha-numeric characters
are allowed.
To Next Page
Loading...
