Test Setup - Test Configurator, Timer, and System
222 FTB-700G/800 Series
S-OAM and MPLS-TP OAM
Pass/Fail Verdict
Pass/Fail Verdict check box when selected (default) enables the use of the
pass/fail verdict. A global fail verdict is declared when any of the following
condition is met: Link Down alarm, Loss Continuity alarm, or any fail
verdict for Frame Delay, Frame Loss, Synthetic Loss (Only applicable to
Ethernet OAM), Frame Delay Failure, Frame Loss Failure, Synthetic Loss
Failure (Only applicable to Ethernet OAM), Loopback Failure, or Test
Failure.
Thresholds
Available with G.8113.1, Y.1731 and MEF OAM Modes when Pass/Fail verdict
is enabled. The verdict is PASS when the measured value is lower or equal
to the threshold value.
Frame Delay Threshold (ms) allows to set the threshold value of
frame delay: 0.001 to 8000 ms (default is 50 ms).
Frame Loss Threshold (%) allows to set the threshold value of frame
loss: 0.001 to 100% (default is 10%).
Synthetic Loss Threshold (%), available with Ethernet OAM (Y.1731
and MEF), allows to set the threshold value of Synthetic Loss: 0.001 to
100% (default is 10%).
To Next Page
Loading...
