Test Results
346 FTB-700G/800 Series
Alarms/Errors
Inject Button
Layer: Allows to select on which layer is the alarm/error to be
generated. Choices depend on the test application and its interface.
Type: Allows to select the type of injection, either Alarms or Errors.
Defect: Allows the selection of the alarm/error defect to be generated.
Choices depend on the selected Layer and Type. Refer to
Alarms/Errors on page 292 for more information.
Mode and Rate/Amount
Manual allows to enter the amount of manual error to be
generated: 1 (default) through 50 or 100 (depends on the selected
error).
Rate allows the selection of the injection rate for the selected error.
The rate must be within the minimum and maximum values
specified.
Max Rate generates the selected error to its theoretical maximum
rate.
Open/Close pop-up button
Selected Alarm/Error
and status
To Next Page
Loading...
