Graphical User Interface Overview
NetBlazer 29
Status Bar
Power level The received signal level per port in dBdsx for DSn signal or dBm for
PDH and optical signals. For Transport electrical interface, LOS on red
background indicates that there is no electrical signal power. For
optical interface, the following background color are used as power
level qualifier:
Green: Power level in range.
Yellow: Power level out-of-range.
Red with “LOS”: Loss of signal.
Red with “Power”: Power level is close to damage.
Gray: Invalid operational range value.
All except for Cable
Te st
Amplitude Amplitude indicates the received signal amplitude per port. Only
available with electrical interfaces.
Transport
Laser ON. The laser icon is not displayed when the laser is off. The laser
icon is only displayed for optical interfaces. The laser is ON by default
when the test is created. The laser control is not affected when turning
off the laser by generating a LOS for example. Refer to Laser Button on
page 535.
All
The status of the received signal pattern per port:
Green: Pattern is synchronized.
Red: Loss of pattern.
Gray: Test is not running (EtherBERT test) or the No Pattern Analysis
(Live) check box is selected.
Transport
EtherBERT
Fibre Channel
Wireless
A connection is established between two testing units either in Dual
Tes t S e t (DTS) or in Loop Up mode. Not available with Intelligent
Apps.
Ethernet
Loopback Tool enabled on the port unused by the main test
application.
Ethernet
Clock synchronization signal clock. The clock icon is followed by the
clock mode: INT for Internal, EXT for External, or RCV for Recovered.
Green: Clock Synchronized.
Red: Loss of clock.
Transport
Ethernet
Fibre Channel
Wireless
Indicates a manual change in the OH bytes transmitted. Not displayed
when using the default OH values.
Transport
The test is in loopback mode. Not displayed when not in loopback
mode.
NI-CSU Emulation
Icon
and/or text
Description Test Application
To Next Page
Loading...
