Test Results
NetBlazer 413
Summary (iSAM)
RFC 6349 Test
Test Status indicates the actual test status as follows.
MTU (bytes) is the validated Maximum Transfer Unit.
Minimum RTT (ms) is the minimum time between the first bit of a
segment sent and the last bit of the corresponding acknowledge.
TCP Throughput
Service indicates the service’s number and name. The pass/fail
verdict icon is displayed next to the service name. A fail verdict is
declared if any of the following conditions occurs: Link Down,
LOS, TCP Throughput verdict failed, or an abort condition
(Timeout, DTS connection lost, unresolved address, user stopped,
configuration synchronization error, invalid MTU).
L->R and R->L indicates respectively the direction from local to
remote and remote to local.
Window indicates the total Max Window (1 KiB = 1024 bytes)
followed by the number of connections and KiB per connection in
parenthesis as follows: (n conn.@ n KiB).
Test Status Description
“--” Test has not started.
In Progress The test is running.
Completed, <Verdict> Test has completed and the test pass/fail verdict is displayed
when enabled. A fail verdict is declared if any of the following
conditions occurs: Link Down, LOS, TCP Throughput verdict
failed, or an abort condition (Timeout, DTS connection lost,
unresolved address, user stopped, configuration
synchronization error, invalid MTU).
Aborted, <reason> Test has been aborted either manually (Stop) or automatically
from an alarm and the reason is displayed as follows:
Link down alarm, LOS alarm, Timeout during execution,
DTS connection failed, Invalid Configuration,
Unresolved addresses, Invalid MTU, User Stopped
To Next Page
Loading...
