Test Results
NetBlazer 433
Summary (S-OAM and MPLS-TP OAM)
Loopback / Test / Frame Delay / Frame Loss /
Synthetic Loss
Note: Either Loopback, Test , Frame Delay, Frame Loss, or Synthetic Loss
(available with Ethernet OAM) statistics are displayed according with the
selected test function (refer to Test Function on page 226).
Status displays the status of the test function.
For Loopback, Frame Delay, Frame Loss, and Synthetic Loss
(available with Ethernet OAM) functions:
For Test function:
Status Description
Idle No Results (function did not run yet).
In Progress Test is in progress. Frames are being transmitted and monitored.
Completed Test is completed:
The test with continuous transmission is manually stopped and replies have been received
or timed out.
The test with continuous transmission is automatically stopped by a test timer and replies
have been received or timed out.
All frames of the test with non-continuous transmission have been transmitted and replies
have been received or timed out.
Aborted Test is aborted. The test with non-continuous transmission is stopped before all the frames
are transmitted.
Status Description
Idle No Results (function did not run yet).
In Progress Test is in progress. RX TST frames are being monitored.
Completed Test is completed. The test is stopped or function is disabled after being In Progress state.
To Next Page
Loading...
