Test Control
532 FTB-700G/800 Series
Discover Remote Button
Connect and Disconnect buttons are only available with RFC 2544,
RFC 6349, and EtherSAM test applications.
Connect establishes the connection with the selected remote
module and sets the remote module into either DTS RFC 2544, DTS
RFC 6349, or DTS EtherSAM test application, depending on the
active test on the local module.
If a remote module is in any busy status a user confirmation is
required to proceed with the Loop Up command.
Following a successful connection, the IP address of the remote
module will be used as the destination IP address for the test.
Disconnect ends the connection between the local and the
remote modules.
Local Module Identification
Module ID is used to easily identify this module in case another NetBlazer
is performing a discovery scan. Up to 16 alpha-numeric characters are
allowed.
To Next Page