Selecting and Starting a Test
NetBlazer 83
Fibre Channel Test Application
3d. Tap the test block to configure the specific test settings (refer to
page 129).
3e. Tap the clock block to configure the clock synchronization (refer
to Clock on page 125).
4. Tap the Timer tab to automatically start and/or stop the test at a given
time or for a specific duration (refer to Timer on page 279).
5. Tap the Start button from the right navigation bar to start the test (refer
to Start/Stop|TX Button on page 558). The Summary result page will
be automatically displayed when the test is started from any Setup
configuration page. For additional results refer to Test Results on
page 287.
6. When the test ends automatically or is manually stopped, the generate
report pop-up is displayed by default. If required, tap Yes to generate a
report of the test results and statistics (refer to Report Button on
page 547 for more information).
To Next Page
Loading...
