Getting Started with Your Unit
MaxTester Series 37
Activating Software Options
6. When the application prompts you to restart the unit, tap OK to close
the message.
Note: At this point, if you have used a USB key to copy your key file, you can
remove it as it is not required to use your new options.
7. Restart your unit to complete the activation process:
7a. Press and hold the On/Off button a few seconds until the unit
beeps once.
7b. Turn the unit on again.
IMPORTANT
Before restarting your unit, you may wish to browse through the
running applications and save any data that you want to keep.
To Next Page
Loading...
