Exmark Lazer Z Series - Deck Leveling-96 Inch Models

Maintenance
g232012
Figure45
1.Singlepointheightadjustmentbolt
2.Frontheightofcutplatemountingbolt
3.Rearheightofcutplatemountingbolt
14.Toadjustthesinglepointsystem,rstloosenthe
frontandrearheightofcutplatemountingbolts.
Note:OnRearDischargeUnits:Themower
deckisattachedinthefrontholesatthefactory
(seeFigure46).Ifneeded,usethebackholesfor
furtheradjustmentwhenlevelingthemowerdeck.
g025558
Figure46
1.Mowerdeck3.Backhole
2.Fronthole
15.Ifthedeckistoolow,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesinglepoint
adjustmentboltbyrotatingitcounterclockwise.
Note:Loosenortightenthesinglepoint
adjustmentboltenoughtomovetheheightofcut
platemountingboltsatleast1/3thelengthof
theavailabletravelintheirslots.Thiswillregain
someupanddownadjustmentoneachofthe
fourdecklinks.
16.Re-tightenfrontandrearheightofcutplate
mountingbolts.
Important:Torquethefrontandrearheight
ofcutplatemountingboltsto67-83ft-lb
(91-113N-m).
17.Repeatsteps8through12.
DeckLeveling–
96InchModels
LevelingtheCenterandWingDecks
1.Positionthemachineonaatsurface.
2.Shutofftheengine,waitforallmovingpartsto
stop,removethekey,andengagetheparking
brake.
3.Checkthetirepressureindrivetiresand
pneumaticfrontcastertires(ifequipped).Proper
inationpressurefortiresis18psi(124kPa).
Adjustifnecessary.
4.Raisethecenterdeckandfoldthewingsby
pressingdownattherearofthedeckliftrocker
switch.Holdtheswitchdownuntilbothwings
arecompletelyfolded.
5.Insertthecenterheightadjustmentpinintothe4
inches(102mm)cuttingheightlocation.
6.Unlocktheleftandrightwingdeckcamlocks.
7.Removeandretainthewingdeckheightofcut
lanyard.
58