Extron electronics SSP 200 - Page 42

SSP200 • Product Configuration Software 34
Output Configuration
HDMI Loop Out
7
Audio — Establishes which audio stream is routed to the HDMI Loop Out. The three
options are No Audio, Follow Input audio, or the Downmix audio.
8
HDCP Status — Indicates the HDCP status of the output device. The HDMI input
negotiates and authenticates HDCP with the sink device, if the sink requires HDCP
encryption.
9
HDCP Mode — Allows the user to either Always Encrypt Output or to Follow
Input. When Always Encrypt Output is selected, the digital input reports as an
HDCP authorized sink to a source. For source devices that require encryption, enable
the HDCP Authorized checkbox (see figure28,
3
, on the previous page).
Listening Mode Setup
This panel allows you to adjust the listening mode depending on the input and source
format (see figure29).
Figure 29. Listening Mode Setup
1
Listening Mode Setup — This drop‑down list allows you to select which input you
want to set the listening modes.
2
Input Source Format/Listening Mode — These drop‑down lists allow you to select
which listening mode you want to assign for each input source format within the
selected input.
29